升降貨梯http://www.jntr168.com/的蓄能器主要是儲存油液多余的壓力能，并在需要時釋放出來。下面濟南天銳升降機械的有關技術人員給大家介紹一下升降貨梯蓄能器使用注意事項。

1、升降貨梯的皮囊式蓄能器原則上應垂直安裝(油口向下)，只有在空間位置受限制時才允許傾斜或水平安裝。不同的蓄能器各有其適用的工作范圍，例如，皮囊式蓄能器的皮囊強度不高，不能承受很大的壓力波動，且只能在-20攝氏度~70攝氏度的溫度范圍內工作。
Should be mounted vertically on a cargo lifter bladder accumulator principle (port down), only when the spatial location of a restricted permit inclined or horizontal mounting. Different accumulators have their applicable scope of work,for example, bladder Bladder accumulators strength is not high, can not afford a lot of pressure fluctuations, and can only work within the -20 degrees C to 70 degrees C temperature range.

2、充氣式升降貨梯蓄能器中應使用惰性氣體(一般為氮?dú)?，允許工作壓力視蓄能器結構形式而定，裝在管路上的蓄能器須用支板或支架固定。
Inflatable cargo lifter accumulator should use an inert gas (usually nitrogen), allowable working pressure accumulator in the form of visual structure may be mounted in the pipeline accumulators must use the support plate or bracket.

3、升降貨梯http://www.jntr168.com/蓄能器與管路系統之間應安裝截止閥，供充氣、檢修時使用。蓄能器與掖泵之問應安裝單向閥，防止液壓泵停車時蓄能器內儲存的壓力油液倒流。
Should be installed between cargo lifter accumulator shutoff valve and piping systems for inflatable, use and maintenance. Accumulator and tuck pump check valve of the question should be installed to prevent parking in the accumulator when the hydraulic pressure of the oil is stored back.